Skip To Content

REG. OUTLET CHECK VALVE

#WE-CV-32RManufacturer: WESTERN ENTERPRISES
Manufacturer #:CV-32R

In-Stock

REVERSE FLOW
CHECK VALVES
For torch and regulator applications,
Western Check Valves guard against
danger caused by plugged tips, overpressurizing
or incorrect startup
procedures. Proper Check Valve
installation helps prevent accidents
caused by gases mixing in hoses,
regulators or cylinders.
NOTE: CHECK VALVES DO NOT
STOP FLASHBACKS. SEE PAGE
34 FOR MORE INFORMATION
ON WESTERN’S FLASHBACK
ARRESTORS.
Western’s reverse flow Check Valves
meet or exceed CGA and OSHA
requirements (Pamphlet CGA-E2) and
feature:
• Flows for cutting up to 12″ of steel
• Machined high quality brass with
stainless steel operating spring
and valve disc
• Low open/close pressures:
1 – 1-1/2 PSIG open valve and
10 oz. reverse pressure to
positively close valve
• 100% tested
• Made in U.S.A.
• Pressure ratings:
(unless otherwise listed)
Oxygen – To 125 PSIG (860 kPa)
Fuel Gas – To 50 PSIG (345 kPa)
• Check Valve Seat Material: A-Size
Models – fluoroelastomer B-Size
Models – Buna-N™

REGULATOR OUTLET BUSHING
MODEL, B-SIZE (9/16″-18)
• Replaces outlet bushing in most regulators
• Flow capacity is 1000 SCFH at 50 PSIG
• Regulator type Check Valve is easily seen
and less subject to contamination, abuse
and damage
• Installed with PTFE thread seal tape on
1/4″ NPT tapered threads

Oxygen RH, 1/4″ NPT Male to B-Size Male, to 125 PSIG (800 kPa)1 CGA-022

In stock

Vendor Catalogues

Check out some of our vendor catalogues.

View All Our Catalogues

LENCO Catalogue

Full list of lenco products.

Download Now